On 9/25/07, Turbo Fredriksson <turbo@bayour.com> wrote:
IT depends with your provider, If they use analog TDM lines you'll be needing Digium TDM400P or TDM2400P with fxo modules, If they can do digital E1 PRI you can use Digium TE120P(one E1 port), TE207P/TE212P(two E1 port), TE407P/TE412P(four E1 port). Or for pci express cards either TE220P or TE420. you can check digium.org for more details of this cards.
You can also use your analog phone devices either connect it through ATA(Analog Telephony Adaptor) example are Linksys PAP2, Digium TDM400P(4-port) with fxs module or TDM2400P (24-port) with fxs module.
AFAIK PRI is the signalling for E1.
Sorry for this. This is most likely a HOWTO or FAQ question, but
it's so much information and documentation to wade through so
I hope someone could take a minute to answer anyway.
If not, no worries. I'll get to it sooner or later :)
I'm trying to understand what Asterisk actually is and the basic
workings... I think I've understand what I need to get going,
except one thing.
How do I connect to a 'normal' (i.e. analog) telephone? That is,
if my company/project have 100% IP telephony, but one of these
phones need to call a analog telephone in another company (or
if I need to call home for any reason :). What do I need from
the 'phone company'? And what hardware?
This is Sweden with Telia as provider if that matters.
IT depends with your provider, If they use analog TDM lines you'll be needing Digium TDM400P or TDM2400P with fxo modules, If they can do digital E1 PRI you can use Digium TE120P(one E1 port), TE207P/TE212P(two E1 port), TE407P/TE412P(four E1 port). Or for pci express cards either TE220P or TE420. you can check digium.org for more details of this cards.
You can also use your analog phone devices either connect it through ATA(Analog Telephony Adaptor) example are Linksys PAP2, Digium TDM400P(4-port) with fxs module or TDM2400P (24-port) with fxs module.
DISCLAIMER1: I've read about BRI, PRI, E1/T1 etc, but the reason
I'm all confused is that they (Telia) don't seem to
understand the question, and also claims that a
PRI == E1.
AFAIK PRI is the signalling for E1.
DISCLAIMER2: I've seen the Digium cards, but due to confusion with
Telia, I'm not sure if I want/need a Digital or an
Analog card... And 'how big'...
if they said they can do PRI you'll be needing a Digium card. but if they can use VOIP go with VOIP to save up from buying the hardware.
HTH
HTH
--
Regards,
Mark Quitoriano, CCNA
Fan the flame...
http://www.spreadfirefox.com/?q=user/register&r=19441
No comments:
Post a Comment